Schumacher Touring Car Wheel Arch Cutting Jig

Schumacher’s Touring Car Wheel Arch Cutting Jig is a must for any Touring Car Racer. One of the trickiest parts of getting a touring body prepped is getting the wheel wells cut out, and now Schumacher is helping to simplify the process. The jig allows accurate and repeatable wheel arch measurement and placement time after time. Additionally, the jig can also measure wing overhang with the handy 10mm step.

How to Use:

• Simply set your car to the required ride height and position the body shell to your desired height.
• Position the jig flush with the outside of the body shell and locate the center of the axle through the hole in the tool. The end radius is different from side to side to prevent body tucks so ensure the jig’s orientation is correct.
• Hold the jig and draw round the inside with a fine marker pen and then carefully cut to the line with a pair of curved scissors.

This product was added to our catalog on December 29, 2015